Hypertherm · Plasma tables
A WiFi USB stick for your Hypertherm plasma table.
EDGE CNCs load part programs from a USB stick and save setups and parts to it. WiFiDrive stays in its USB port, looks to the Hypertherm like any stick, and gets your cut files there over your own WiFi.
- Works as it ships: the Hypertherm reads it as is.
- Load a cut file from it as from any stick.
- If your Hypertherm won’t read it, a full refund within 30 days.
Models
Every Hypertherm control.
WiFiDrive goes in its USB port on every one.
EDGE Connect
- EDGE Connect
- EDGE Connect TC
EDGE Pro
- EDGE Pro
- EDGE Pro Ti
MicroEDGE Pro
- MicroEDGE Pro
The stick
What a Hypertherm asks of it.
- Loads a partPhoenix loads it from a USB stick into working memory, or copies it to the hard drive; EIA or ESSI files
- Where on the stickParts, setup files (*.ini), updates and cut charts are read from the stick's root folder
- PortEDGE Connect TC: a USB connector with a cover on the front console; MicroEDGE Pro: one front, four rear; one hub at most
- Writes to itParts, setup files, cut charts, and system files for troubleshooting, loose or zipped
- WiFiDrive’s layoutThe one it ships with
- Sourceshypertherm.com, hypertherm.com (2), hypertherm.com (3), hypertherm.com (4), hypertherm.com (5)
Will it work with your Hypertherm?
If your Hypertherm reads a USB stick, it reads WiFiDrive. If yours doesn’t, send it back within 30 days for a full refund.