Heidenhain · CNC controls
A WiFi USB stick for your Heidenhain control.
TNC controls copy a program from the stick to their own drive before running it. WiFiDrive stays in its USB port, looks to the Heidenhain like any stick, and gets your programs there over your own WiFi.
- Works as it ships: the Heidenhain reads it as is.
- Run a program straight from it, as from any stick.
- If your Heidenhain won’t read it, a full refund within 30 days.
Models
Every Heidenhain control.
WiFiDrive goes in its USB port on every one.
TNC7
- TNC7
- TNC7 select
- TNC7 basic
- TNC7 go
TNC
- TNC 640
- TNC 620
- TNC 320
- TNC 128
CNC PILOT
- CNC PILOT 640
MANUALplus
- MANUALplus 620
iTNC
- iTNC 530
The stick
What a Heidenhain asks of it.
- Loads a programCopies it to the control's hard disk before editing or running; the manual says to use the USB port only for transfer and backup
- FormatSticks with FAT/VFAT, exFAT or NTFS (NC software 34059x-11); another file system is refused as soon as it is plugged in
- PortTNC 640: one front USB 2.0 port and four rear USB 3.0 ports; a hub may raise an error to acknowledge
- Also readsDXF drawings from the network or a USB stick
- Writes to itBackups and copies from the file manager
- WiFiDrive’s layoutThe one it ships with
- Sourcescontent.heidenhain.de, heidenhain.us, heidenhain.us (2), manualslib.com (snippet)
Will it work with your Heidenhain?
If your Heidenhain reads a USB stick, it reads WiFiDrive. If yours doesn’t, send it back within 30 days for a full refund.