A WiFi USB stick for your laser cutter or engraver.
WiFiDrive stays in the laser’s USB port and looks to it like any USB stick. Your jobs get there over your own WiFi, from the office or the floor: no more walking the stick to the xTool, the Ruida or any laser that reads one.
- Nothing to install on the laser: for it, this is a USB stick.
- Load a job from it as from any stick.
- If your laser won’t read it, a full refund within 30 days.
WiFiDrive works with your brand.
Check models, its photos and what its control asks of the stick.
LS lasers copy .rd jobs from the stick; HP lasers read .ud5 jobs at the panel.
7 modelsBoss Laser
FriendessThe FSCUT8000's Windows host imports cutting tasks by network or USB device.
14 modelsFriendess
OMTechIts Ruida lasers copy an .rd job from a FAT32 stick under 16 GB into memory.
14 modelsOMTech
RuidaCopies jobs from the root of a FAT16 or FAT32 stick into memory, and back to it.
11 modelsRuida
Thunder LaserCopies .rd jobs from the root of a 16 GB or smaller stick into memory.
11 modelsThunder Laser
TopWisdomCopies jobs between a U disk and the controller's memory, both ways.
8 modelsTopWisdom
TrocenReads and writes job files on a U disk and upgrades its firmware from one.
9 modelsTrocen
TrumpfTruLaser controls import and export program files over USB and the network.
14 modelsTrumpf
F1 Ultra and F2 Ultra open an .xf job from a USB drive on the touchscreen.
2 modelsxTool
Will it work with your laser?
If your laser reads a USB stick, it reads WiFiDrive. If yours doesn’t, send it back within 30 days for a full refund.